Fragmentation - gold-forming

The internal crack-gold-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-skin-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show-show

The slides seen near the 20G water pipe, the cold wall bending horizontally, are the line slides. The pictures are taken on the outer wall of the tube, and the two below are taken under the DIC (Snote: Micro-interfault).

The following are the products that will be used for gold phase:

1. FY-QG-65, a Fuyunkin co-moder, cut the sample gold and cut down a small piece, horizontal or vertical, as required by the sample, to facilitate mosaicing.

II. Kim Co-simworks:

Fuyun materials gold-specific sandpaper: 230mm diameter without glue 600# 1200# 2500#   

III. LEAVE THE FIELDS OF THE KING PHOTOS:

Fuyun materials gold-phased photo fabric: 230 mm in diameter velvet/splendon

Fuyun materials, Fresco-Frestilt Spraying: 1/3 micrometre

Fuyun machine: manual in no-extreme-speed grinder

Pressure: Fixed, neutral, stable, without too much pressure.

Time: 2-5 minutes, whichever is the same, the scratches of the thin sandpaper are almost removed.

Rotation speed: 200 turns

Raarboard direction: Clockwise

During polishing: The polished rags need to be immersed early, the polished fluid is down in the centre position and handwashing is added to its lubrication.

Pour: A little bright, no scratches, and can move on.

During polishing: The polished rags need to be immersed early, the polished fluid is down in the centre position and handwashing is added to its lubrication.

Pouring: The brightness is very high.

Corrosion observation:

Fuyun gold microscope (magnification multiple: 50X, 100X, 200X, 500X, 1,000X)

The following are used for corrosive reagents: